Connect with the MacPhee Ford service team for assistance.) As soon as the door locks begin cycling, press any button on the Ford key fob you wish to program. The door locks will cycle again to confirm your Ford key fob programming and that the remote is ready to use. Repeat Step 3 for any additional key fobs you need to program. Step 3: Do a secondary check on the anti-theft light. If it is no longer blinking, turn the key to the “off” position and let your car sit for a couple of minutes. This allows the system to fully reset itself, or your car won’t start. Step 4: Try starting the car fully. Put your key back into the ignition and turn the car all the way on. FORD FOCUS 1.6TDI CC2 2009Following flat battery I get the following messages: Transmission Malfunction Engine MalfunctionI have 12.4v at battery. Engine will not turn over. All ingnition and dash lig … read more Ford Services. Ford Technology. FordPass. Keys and Locks. Door Locks and Alarms (6) Key Fob and Remote Start (3) MyKey (3) Replace and Reprogram Keys (4) More Vehicle Topics. When the alarm is reset, the unit will sound 4 loud chirps if the alarm had triggered during the alarm set mode. 11) STARTING When the alarm is reset the vehicle after dash led will be off, the vehicle THE VEHICLE To start the the alarm has been reset. can be started within 60 seconds. After 60 seconds the immobiliser will be armed, dash led on. U4Z7. try this. With the key in the ignition, turn the ignition on to the 1 position, then off and then again three times, then once more and leave it at I. A beep will sound showing that the system is set to program. Now press the unlock button on the remote. Press the unlock button on any other remotes that you have to program at the same time. Use a flathead screwdriver to open the transponder key and get the Radio Frequency Identification (RFID) chip. Be careful with this step so you don’t ruin the transponder key. Once you get the RFID chip, you can bypass the PATS system. Get the chip and place it close to the ignition. Method 2: Pulling the fuse. The easiest way to perform an ECU reset is by removing the fuse from the fuse box. It is a very simple process, and all you have to do is pull out the car key, remove the fuse from the fuse box, and then put it back after about 15 to 20 seconds. Doing this clears any long-term memory stored in the car’s ECU. To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to confirm the digit and resume, replicate the procedure until you have entered the full code. This should let you start your Ford Mustang without having to remove the immobiliser. The red immobiliser light has always flashed at about a 2 second speed when the ignition is off. That is what it is supposed to do. Are you saying that the engine won't start ? If I understand your post the engine does start and the immobiliser light goes out when the engine is running. If the key was not recognised then the engine would not start.

how do i reset my ford focus immobiliser